Advertisement
4. Mount routertop to your custom base.
When mounting the routertop to your own base or leg set, use
the routertop's predrilled mounting holes with the bolts and
cross dowels provided. Use of any other hardware or mounting
method will void the warranty. You must locate and drill (8)
mounting holes according to the drawing below. Furthermore,
you must drill (8) cross dowel holes to intersect the mounting
holes, as shown to the right.
Skip step 4 if you
purchased a Bench Dog
ProTop Cabinet!
5. Attach the miter track to the routertop.
First install (4) 1/4" cross dowels in the cabinet's front
stretcher. Use the (4) 1/4-20 x 2" phil. flat head machine
screws in track holes.
All distances are from center of hole to center of hole.
123.8
4.875"
Dimensions in mm/inches.
Miter Track
75.8
192
2.984"
7.559"
1/4-20 x 2"
phil. flat head
machine screw
Page 4
Locate the center
hole 3/4" from top of
panel, as shown.
Cross Dowel
The above drawing is provided to assist
you in locating the mounting holes for the
base you build. It is your responsibility to design an
adequately strong base to support the routertop, a
416
16.378"
Top View
Router Insert Plate
Miter Track
128
192
5.039"
5
Bolt
Routertop
of cross dowel
3/4"
1-5/8"
The cross dowel hole
is 7/16" in diameter,
9/16" deep!
Cabinet Panel
router, and your work.
123.8
187.3
7.374"
292.1
11.5"
75.8
Drill the
5/16" diameter
routertop mounting
holes 1-5/8" deep,
as shown.
Advertisement
