Utility Menu - Shure AXT630 User Manual

AXT630 Antenna Distribution System
Antenna Cascade
Auto
The ports will activate when a connected device supplies 12-15 V DC to the
port.
On
The ports are continuously active, independent of voltage applied by a con-
nected device.

Utility Menu

Press and hold both arrow keys to enter and exit the utility menu, which is
used to access network and display settings.
SET
IP Address Mode: Automatic
This is the default setting for use with a DHCP server, which automatically
assigns an IP address.
1. Navigate to the IP Mode menu and press the SET key.
2. Use the arrow keys to highlight Automatic.
3. Press the SET key.
4. Use the arrow keys to move the ► to select OK to save or Cancel to
discard, and then press the SET key.
IP Address Mode: Manual
Use manual IP addressing to set the IP address and subnet mask when a
DHCP server is not available.
1. Navigate to the IP mode menu and press the SET key.
2. Use the arrow keys to highlight Manual.
3. Press the SET key to enable editing of the IP address and the subnet
mask.
4. Use the arrow keys to move the ► to select IP: or Sub:
5. Use the arrow keys and the SET key to edit the IP address and subnet
mask.
6. Use the arrow keys to move the ► to select OK to save or Cancel to
discard, and then press the SET key.
MAC (MAC Address)
Displays the MAC address, which is an embedded, uneditable identification
number unique to each device. Used by the network and WWB software to
identify components.
Device ID
This eight-character name is displayed when this device is detected on other
network devices or in WWB software.
1. Press SET key to enable editing.
2. Use the arrow keys to change the characters.
3. To finish editing, press the SET key until none of the characters are
highlighted.
2017/10/12
hold both arrow keys
Antenna Power
ON
The antenna ports supply 12-15 V DC to power active antennas.
OFF
Turns off DC voltage at the antenna ports.
Network Status
Active
Indicates connectivity with other devices on the network.
Inactive
No connectivity with other devices on the network.
Note: IP address must be valid to enable networked control.
Serial Number
Displays the serial number.
Firmware
Displays the version of firmware installed on this device.
Brightness
Sets the brightness of the LCD to low, medium, or high.
Display Invert
This changes the LCD menu from white text on dark background to dark text
on a light background.
Front Panel Lock
Locks or unlocks the navigation buttons to prevent accidental or unauthorized
changes to settings.
On
Locks the navigation buttons.
Off
Unlocks the navigation buttons.
Power Switch Lock
Lock the power switch to ensure that power is not accidentally turned off.
On
Locks the power switch.
Off
Unlocks the power switch.
Setting the Fan Speed
The cooling fan has the following speed options:
• Low Speed = fan is always on, at a lower speed for quiet operation
• High Speed = fan is always on, at a higher speed for maximum cooling
• Automatic = fan will operate only when the internal temperature becomes
too warm
Note: Speed may switch from Low to High if additional cooling is needed to
protect the component.
1. Simultaneously press and hold the ▲ and ▼ buttons to access the utility
menu.
2. Use the arrow buttons to scroll to the Fan setting.
Shure Incorporated
5/9