Cisco ASA 5505 Getting Started Manual page 44

Configuring the Easy VPN Hardware Client
You can perform this configuration procedure by using ASDM or by using the
command-line interface. This section describes how to perform the configuration
using ASDM.
To configure the ASA 5505 as an Easy VPN hardware client, perform the
following steps:
At a PC that has access to the inside interface of the ASA 5505, start ASDM.
Step 1
a.
b.
c.
In the ASDM window, click the Configuration tool.
Step 2
Click VPN, and then check the Enable Easy VPN Remote check box.
Step 3
If you check the Enable Easy VPN Remote check box, Easy VPN is enabled on
the device when you click Apply. If you uncheck it, when you apply the
configuration changes, you are prompted to specify if you want to clear the entire
Easy VPN configuration or whether you just want to disable the Easy VPN client
temporarily.
The Easy VPN Remote configuration panel appears.
Cisco ASA 5505 Getting Started Guide
5-6
Start a web browser.
In the address field of the browser, enter the factory default IP address in the
address field: https://192.168.1.1/.
Note Remember to add the "s" in "https" or the connection fails. HTTPS
(HTTP over SSL) provides a secure connection between your
browser and the adaptive security appliance.
In the window that requires you to choose the method you want to use to run
the ASDM software, choose either to download the ASDM launcher or to run
the ASDM software as a Java applet.
Chapter 5 Scenario: Easy VPN Hardware Client Configuration
78-17612-01