Failures - Smeg 155620 Instructions For Use Manual

Failures

Failure
The machine does
not work
(display is not
illuminated).
Water does not
enter the machine.
If the washing machine identifies failures in the
operation, it reports it immediately. Sound alarm
is heard and the display reads ERROR. Number
identifies the type of failure.
In some cases you may attempt removing certain
failures yourself (see the chart below), and the
machine will continue to perform the operation after
pressing the START knob (F). The machine signals
failures immediately after detecting them and stops
the program, except for heater failure, where the
machine completes the washing program without
heating water (FAILURE 1).
In case the machine signals faults number
you have to wait for at least 2 minutes
before you can open the door of the
washing machine.
Interferences from the ambient (for example
electrical wiring) could induce signalization of
different faults. In such cases:
- switch the appliance off, and wait for a few
seconds;
- switch the appliance back on and repeat the
washing program.
If the fault repeats, call authorized service shop.
Possible cause
Machine is not powered.
Filter is not tightly screwed in.
Inlet pipe is not tightly
screwed to the machine or to
the water faucet.
Outlet pipe fell to the floor.
Remedy
Check if:
• plug is in the socket,
• there is power in the socket,
• the fuse is OK.
Tighten the filter properly.
Tighten the inlet pipe.
Affix the outlet pipe to the drain.
29