Omega Post-Type Wall Mount Shelving Assembly Instructions

Step 1 Unpack carton to confirm all necessary components are included.
Step 2 Determine the desired height and location of the unit.
Then mark the center points for all brackets of the unit
being mounted. Be certain the points are in direct line
vertically and horizontally. This is essential for shelf or
shelves to be mounted correctly.
Step 3 Prepare mounting holes. Mounting screws or bolts
are not supplied with units due to varied types of walls
or supports these units are to be mounted on. It is the
responsibility of the user to make certain that the mounting
surface and the method of mounting is suitable and
sufficient to support the anticipated weight that will be
placed on the unit. Each intermediate and mounting bracket
has two 11/32˝ diameter clearance holes for mounting.
Remove the bolts from the ends of the posts.
Step 4
SAVE THESE BOLTS
The bottom of the post is the end which has the longest
Step 5
distance between the first groove and the end of the post.
Count from the bottom of the post and place plastic split
sleeves (See Diagram #1) onto groove where you would like
the first post mount bracket located.
Slide the post mount bracket down from the top of the
Step 6
post onto the plastic split sleeves. (See Diagram #2)
If a two, three, or four tier unit is being assembled, slide
Step 7
down an intermediate bracket.
For a two, three, or four tier unit repeat steps 5, 6, and 7
Step 8
until all brackets have been mounted.
Repeat steps 4 through 8 for the remaining post(s)
Step 9
DIAgRAM 1
ASSEMBLY
INSTRUCTIONS
Post-Type Wall Mount Shelving
brackets (top & bottom) and bolts to secure
Each post mount bracket includes 1 pair of plastic
sleeves and 2 chrome plated shelf caps
33˝ Posts have 1 intermediate bracket
54˝ Posts have 2 intermediate brackets
63˝ Posts have 3 intermediate brackets
DIAgRAM 2
Material List
Each post contains 2 mounting
bracket to the post ends
continued on backside