Table of Contents
Advertisement
Chapter 4
Configuring the PA-2FEISL
The ouputs that appear in this document may not match the output you receive when running these
Note
commands. The outputs in this document are examples only.
Cisco 7100 Series Routers
With the show interfaces type slot/port command, use arguments such as the interface type (for
example, fastethernet) and the port number (slot/port) to display information about a specific interface
only. The following example of the show interfaces fastethernet command shows information specific
to a Fast Ethernet interface on a PA-2FEISL in slot 4:
Router# show interfaces fastethernet 4/0
FastEthernet4/0 is administratively down, line protocol is down
Hardware is DEC21140, address is 1.1.1.11 (bia 0000)
Internet address is 10.0.0.0
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec, rely 255/255, load 1/255
Encapsulation ARPA, loopback not set, keepalive not set, fdx, 100BaseTX
ARP type: ARPA, ARP Timeout 4:00:00
Last input 3:08:43, output 3:08:42, output hang never
Last clearing of "show interfaces" counters 2:58:36
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
For the Cisco 7206VXR and the Cisco 7206 router shelves, the show interfaces command requires a
Note
shelf number in the format show interfaces type shelf number/port adapter slot/interface.
The Fast Ethernet interface port adapter is numbered as port adapter 4. The Fast Ethernet ports on the
PA-2FEISL are interfaces 0 and 1.
Cisco 7200 Series and Cisco uBR7200 Series Routers
With the show interfaces type slot/port command, use arguments such as the interface type (for
example, fastethernet) and the port number (slot/port) to display information about a specific interface
only. The following example of the show interfaces fastethernet command shows information specific
to a Fast Ethernet interface on a PA-2FEISL in slot 4:
Router# show interfaces fastethernet 4/0
FastEthernet4/0 is administratively down, line protocol is down
Hardware is DEC21140, address is 1.1.1.11 (bia 0000)
Internet address is 10.0.0.0
MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec, rely 255/255, load 1/255
Encapsulation ARPA, loopback not set, keepalive not set, fdx, 100BaseTX
ARP type: ARPA, ARP Timeout 4:00:00
Last input 3:08:43, output 3:08:42, output hang never
Last clearing of "show interfaces" counters 2:58:36
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
OL-3475-02
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 watchdog, 0 multicast
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets, 0 restarts
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
PA-2FEISL 100BASE-T Fast Ethernet/ISL Port Adapter Installation and Configuration
Checking the Configuration
4-11
Advertisement
Table of Contents
