Table of Contents
Advertisement
Relay Driver Module Configuration
Connecting
User Inputs
22 Configuring the Relay Driver Module
This section gives guidelines to configure the Relay Driver Module for
installation, including:
•
Connecting User Inputs
•
Setting Interrupt Priority Jumpers
•
Setting the Logical Address Switch
•
Setting Internal Power Supply Level
User inputs to the Relay Driver Module are via 60-pin ribbon connectors to
the P200 and P400 connectors on the faceplate as shown in Figure 2-1. To
connect the ribbon cable to P200 or P400, push the ribbon connector pins
onto the P200 or P400 pins until the side latches engage the ribbon cable
connector.
You can also use the ribbon connector leads to set Relay Driver Module
operations, as shown in "Setting Relay Driver Module Operation". Tables
2-1 through 2-4 show the pin definitions for the P200 and P400 connectors
for 36-channel and 72-channel operation.
Figure 2-1. Connecting User Inputs
Advertisement
Table of Contents
