Summary of Contents for Generac Power Systems 0H7699
Page 1
Generac 0H7699 Wireless Module: Data Sheet/Manual 0H7699 module with connector for external antenna (see approved antennas listed below). 0H7699 module for wire antenna (see approved antennas listed below).
Page 2
November 2, 2010 Compliance Statement (Part 15.19) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may cause undesired operation.
Page 3
November 2, 2010 Section 7.1.5 of RSS-GEN Operation is subject to the following two conditions: 1) this device may not cause interference, and 2) this device must accept any interference, including interference that may cause undesired operation of the device. Section 7.1.4 of RSS-GEN This device has been designed to operate with the antenna(s) listed below, and having a maximum gain of 2.0 dB.
Nearson S467AH-915 (SMA rev polarity). OEM Responsibilities to comply with FCC and Industry Canada Regulations The 0H7699 Module has been certified for integration into products only by OEM integrators under the following conditions: 1. The transmitter module must not be co-located or operating in conjunction with any other antenna or transmitter.
Page 5
FCC and Industry Canada authorization. End Product Labeling The 0H7699 Module is labeled with its own FCC ID and IC Certification Number. If the FCC ID and IC Certification Number are not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module.