Table of Contents
Advertisement
7.2
Adjusting the cover
The cover and brush (1) can be adjusted to suit the way of working and your requirements, thus
always ensuring that the suction is working most effectively.
1. Unlock the cover with the locking
function (2) and rotate 90°
to the open position.
2. Rotate the cover (1)
to the desired position.
3. Use the locking function
to lock the cover (1) in place.
7.3
Usage information
While operating, always hold the tool
against the ground with two hands.
For holding position, see figure.
Always move the tool parallel to the floor,
so that the sanding plate is in full contact.
Otherwise the suction may not work optimally.
When sanding on a level surface,
do not place too much pressure on the
sanding plate.
This can have a negative impact on the sanding result and on the wear of the plate.
Never sand for too long in one position. Risk of burn in! Keep the tool constantly moving!
8.
Maintenance and care
The GECKO FLEX is largely maintenance-free. The lubrication of the roller bearings and of the
gears is sufficient for the lifetime of the tool.
We recommend regularly blowing out the air inlets and outlets with compressed air while the
tool is switched off. Otherwise these openings can become clogged, blocking the tool.
Caution!
Poor maintenance can cause the motor to overload more rapidly, and lead to increased
vibration and noise emissions.
8.1
Replacing the sanding disc
Caution! Risk of injury!
Before replacing the sanding disc, pull out the mains plug.
Only operate the spindle lock when the motor has come to a stop.
12
BILD
1
2
09/2010
Advertisement
Table of Contents
