Advertisement
3.1
Precautions for Disassembly
3.1.1 Removing the speaker hardware fixture (J2B-0023-
00) and holder (J1K-0019-00)
(1) Remove the speaker lead from the holder hook. <1>
(2) Remove the speaker connector from the display unit con-
nector (CN5). <2>
(3) When removing the speaker hardware fixture, insert a flat-
head screwdriver at the position shown in Figure 1-1 and
tilt it in the direction shown by the arrow. <3>
(4) To remove the holder, insert a flat-head screwdriver into
tab of the holder and tilt it in the direction shown by the ar-
row. <4>
CN5
<2>
3.2
Precautions for Reassembly
3.2.1 Installing the holder (J1K-0019-00) and speaker hard-
ware fixture (J2B-0023-00)
(1) Insert two tabs of the holder (J1K-0019-00) into the hollows
in the top of the panel. <1>
(2) Push the two tabs of the holder in on the opposite side of
those in step 1 above and fit them into the hollow in the bot-
tom of the panel. <2>
Note:
Push in the holder until it snaps in place.
(3) Install the speaker holder onto the panel. <3>
Note:
To improve water resistance, fit the panel into the groove
of the holder.
1-6 (No.RA019<Rev.001>)
DISASSEMBLY
<3>
<1>
Fig.1-1
<4>
Fig.1-2
SECTION 3
(4) Place the speaker into the speaker holder.
Note:
The speaker must not ride on the holder rib.
(5) Place the spacer on the speaker.
(6) Insert the hardware fixture (J2B-0023-00) into the hollow of
the panel as shown in Figure 2-3, then push two parts of
the hardware fixture and fit it into the hollow of the top of the
panel. (Fig. 2-3 <4>)
Note:
Push in the hardware fixture until it snaps in place.
(7) Insert the speaker connector into the display unit connector
(CN5).
(8) Place the speaker lead on the holder hook.
<1>
<1>
<2>
Fig.2-1
Spacer
Speaker
Speaker holder
<3>
Fig.2-2
<4>
Fig.2-3
Hide quick links:
Advertisement
