Advertisement
1. IMPORTANT SAFETY INSTRUCTIONS ................................................................................. 4
2. COOKTOP MEASUREMENTS ............................................................................................... 6
3. POSITIONING THE COOKTOP AND LOCATION REQUIREMENTS .................................... 7
3.1 Mounting ......................................................................................................................................................... 9
4. ELECTRICAL CONNECTION ............................................................................................... 10
NOTE: THIS APPLIANCE MUST BE INSTALLED SOLELY AND EXCLUSIVELY BY A QUALIFIED
TECHNICIAN. ANY TECHNICAL PROCEDURES MUST BE CARRIED OUT BY AN AUTHORIZED
TECHNICIAN.
INSTRUCTIONS FOR THE INSTALLER: these are intended for the qualified engineer who is able to
install, commission and test the appliance
Table of Contents
3
Advertisement
Related Manuals for Smeg S2772TCU
Summary of Contents for Smeg S2772TCU
-
Page 1: Table Of Contents
1. IMPORTANT SAFETY INSTRUCTIONS ... 4 2. COOKTOP MEASUREMENTS ... 6 3. POSITIONING THE COOKTOP AND LOCATION REQUIREMENTS ... 7 3.1 Mounting ... 9 4. ELECTRICAL CONNECTION ... 10 NOTE: THIS APPLIANCE MUST BE INSTALLED SOLELY AND EXCLUSIVELY BY A QUALIFIED TECHNICIAN. -
Page 2: Important Safety Instructions
IMPORTANT: Installation and grounding must comply with applicable codes. Observe all government codes and ordinances. NOTE: This cooktop is NOT designed for installation in manufactured (mobile) homes or for installation in Recreational Park Trailers. DO NOT install this cooktop outdoors. - Page 3 It is the responsibility of the installer to comply with the installation clearances specified on the model/serial I.D. plate. The I.D. plate is located under the cooktop base. ELECTRICAL GROUNDING REQUIRED: See the “4. Electrical connection” section. It is the customer’s responsibility:...
-
Page 4: Cooktop Measurements
NOTE: Observe all governing codes and ordinances. Some cabinet and building materials are not designed to withstand the heat produced by the cooktop. Check with your builder or cabinet supplier to make sure that the materials used will not discolor, delaminate or sustain other damage. -
Page 5: Positioning The Cooktop And Location Requirements
It is the responsibility of the installer to comply with installations guidelines specified on the model/ serial I.D. plate. The model/serial I.D. plate is located on the bottom of the cooktop burner box. The cabinet opening dimensions that are shown must be used. Given dimensions are minimum clearances. - Page 6 Cooktop width 30” ” 758 mm 750 mm 36 ” ” 900 mm 892 mm Cooktop width 30 “ ” 762 mm 721 mm 36 “ 33 ” 914 mm 863 mm Instructions for the Installer MODEL WITH FRAME MINIMUM DISTANCE 2 ”...
-
Page 7: Mounting
(A) provided, as shown in the figure. When fixing the cooktop to the cabinet, use only the holes provided, as illustrated here. NOTE: This appliance must not be built-in above a dishwasher. -
Page 8: Electrical Connection
Your local codes and ordinaces, of course, take precedence over these instructions. Complete electrical connections according to local codes and ordinances. This cooktop must be connected to a grounded, metallic, permanent wiring system, or a ground connector should be connected to the ground terminal or wire lead on the cooktop. - Page 9 Connect the white wire from the appliance to the neutral (white colored) wire in the junction box. NOTE: Both power cables coming out of the cooktop, must be connected according to the diagrams shown in pictures 1 and 2 pic.1)