Getting Started - Remington ULTIMATE SERIES ROTARY SHAVER R7 Manual

• Do not plug or unplug the appliance with wet hands.
• Do not twist or kink the cable, or wrap it round the appliance.
• This appliance is not intended for commercial or salon use.
PARTS
1. On/off switch
2. Head and cutter assembly
3. Hair pocket
4. Charging indicator light and low
battery indicator (R7 only)
5. Fuel gauge (R8 only)
6. Pop-up trimmer
7. Trimmer release button
8. Charging pins

GETTING STARTED

Charge the shaver:
Note: This shaver is for cordless use only.
1. Ensure the appliance is turned off.
2. Connect the charging stand to the adaptor and then to the mains.
3. Place the shaver in the charging stand.
4. Charge for at least 24 hours when using for the first time.
• To preserve the life of your batteries, let them run out every 6 months then recharge
for 24 hours.
• The appliance adapts automatically to a mains voltage between 100V and 240V.
R7
• When the charge is low, the upper LED will illuminate red.
• When charging the lower LED will illuminate green. When fully charged both LEDs will
be off.
• Allow 4 hours for a full charge.
R8
• The fuel gauge will display the amount of charge left when the shaver is on. When
charging, the LEDs cycle in a rotating pattern. When fully charged all LEDs will come
on then turn off.
• Allow 90 minutes for a full charge.
9. Charging stand
10. Comb (R8 only)
11. Comb adjustment dial (R8 only)
12. Beard trimming attachment (R8 only)
13. Adaptor (not shown)
14. Headguard (not shown)
15. Cleaning brush (not shown)
16. Storage case (not shown)
5