Intel H310 Technical Manual page 42

The optional settings: [None]; [Hardware RTS/CTS]; [Software Xon/Xoff].
Data Bits
The default setting is: [8].
*This item may or may not show up, depending on different configuration.
Parity
The default setting is: [None].
*This item may or may not show up, depending on different configuration.
Stop Bits
The default setting is: [1].
*This item may or may not show up, depending on different configuration.
4 PC Health Status
Press [Enter] to view current hardware health status, make further settings in
'SmartFAN Configuration' and set value in 'Shutdown Temperature'.
► SmartFAN Configuration
Press [Enter] to make settings for SmartFan Configuration:
SmartFAN Configuration
CPUFAN / SYSFAN Smart Mode
The optional settings are: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
CPUFAN / SYSFAN Full-Speed Temperature
Use this item to set CPUFAN/SYSFAN full speed temperature. Fan will run at full
speed when above this pre-set temperature.
CPUFAN / SYSFAN Full-Speed Duty
Use this item to set CPUFAN/SYSFAN full-speed duty. Fan will run at full speed
when above this pre-set duty.
CPUFAN / SYSFAN Idle-Speed Temperature
Use this item to set CPUFAN /SYSFAN idle speed temperature. Fan will run at idle
speed when below this pre-set temperature.
CPUFAN / SYSFAN Idle-Speed Duty
Use this item to set CPUFAN/SYSFAN idle speed duty. Fan will run at idle speed
when below this pre-set duty.
37