Setting Up Lifebook Security Panel; Passwords - Fujitsu LifeBook P Series Manual

Setting Up Lifebook Security Panel

When you receive your Notebook, the security
panel application is pre-installed without any
passwords. The following sections provide
detailed information on your security panel, how
to set, change or remove passwords.
Numbered Buttons
Use these buttons to enter your password.
(Figure 2-18)
Enter Button
After entering the button strokes, push this button
to enter the password into the Notebook. (Figure
2-18)

Passwords

The user and supervisor password may be set
on this Notebook. A supervisor password is
typically the same for all tablets and notebooks
in a work group, office, or company to allow for
system management. Individual computers in a
group environment should not use a common
password. A password consists of one to five
button strokes plus the enter button. A valid stroke
consists of pushing one or up to four buttons
simulta-neously.
The following are valid button strokes:
• Pushing [4] by itself
• Pushing [2] and [3] at the same time
• Pushing [1], [2], and [4] at the same time
• Pushing [1], [2], [3], and [4] at the same time
The following are valid passwords. The numbers
within braces ({ }) are button strokes using more
than one button.
• {[2]+[3]}, [1], [Enter]
• [4], [enter]
• {[1]+[3]}, {[2]+[3]+[4]}, [1], [4], [2], [Enter]
Setting Passwords
When shipped from the factory, no passwords
are set. You have a choice of having no password
or setting a supervisor and user password. You
must set the super-visor password before the
user password.
22
a The purpose of supervisor password is to
be able to bypass the user password in
case the user password is forgotten. The
supervisor password alone will not lock
the system.
a You must set the supervisor and user
passwords for the security panel to work.
Setting Supervisor Password
You must have set a supervisor password before
setting any user passwords. The supervisor
password can bypass the user password.
1. Go to the Start menu.
2. Click on Run.
3. Type in:
C:\Program Files\Fujitsu\Security
Panel Application\Supervisor\
FJSECS.EXE, then press [Enter].
4. Follow the on-screen instructions to set the
Supervisor password.
Setting User Password
1. Go to the Start menu.
2. Click on All Programs.
3. Click on Security Panel Application ->
Security Panel Application.
4. Follow the on-screen instructions to set the
user password.
You may change or remove the supervisor
or user password by repeating the steps
defined above.