Table of Contents
Advertisement
Attaching the Velcro (Optional)
1. Peel the protective paper off the Velcro circles and firmly press the
circles into the circular holes at the rear of the clip.
2. Temporarily hold the SMC2664W in the desired location and check
the signal quality is acceptable. Peel the protective paper off the Velcro
strip and stick the strip in the chosen location.
Attaching the USB Cable
1. Select an available USB port on the PC.
2. Carefully insert the USB cable's Type-A plug (i.e., the flat plug) into
the USB port and press until it is firmly seated in the port. Insert the
other end of the cable into the SMC2664W.
Warning: The plugs will only go into their respective slots one way. If the
plugs do not comfortably enter the slots, turn them around and
try again.
A
TTACHING THE
V
(O
ELCRO
PTIONAL
)
7
Advertisement
Table of Contents
