SMC Networks 5MC2671W User Manual page 30

U I
TILITY NSTALLATION AND
Menu
Device Name
Basic Rates
Data Rates
Preamble Type The access points and client card drivers have a radio setting
Beacon Interval The beacon signals allow the wireless devices to maintain
RTS Threshold You may configure the access point to initiate an RTS frame.
Frag. Threshold The Fragmentation Threshold can be set between 256 and
Operation Mode
Mode
BSSID
18
C
ONFIGURATION
Description
The name of the wireless access point. (Default: SMC2671W)
The highest rate specified is the rate the access point will use
when transmitting broadcast/multicast and management
frames. Available options are: 1, 2, 5.5, and 11 Mbps. (Default:
2 Mbps.)
Set the data rate transmitted from the SMC2671W. The lower
the data rate, the longer the transmission distance. Available
options are: 1, 2, 5.5, and 11 Mbps. (Default: 11)
for RF Preamble. If you are not sure whether all the clients and
access point radios in your wireless network support the Short
RF preamble, then leave this setting to the default (Long).
contact with each other. They may also carry
power-management information. (Default: 100)
If the packet size is smaller than the preset RTS threshold size,
the RTS/CTS mechanism will NOT be enabled. (Default: 2,347
which means Disabled)
2,346. If the packet size is smaller than the preset fragment
size, the packet will not be segmented. (Default: 2,346 which
means Disabled)
This may be set to Access Point, Range Extender, or Ethernet
Adapter. (Default: Ethernet Adapter)
Basic Service Set ID. The MAC address of the access point to
which the adapter is connected in an infrastructure network. In
an ad hoc network, the BSS ID is a random number generated
by the first adapter that communicates with other clients in the
network. The BSS ID of the other clients will then be set to the
same value.