Advertisement
Preparation to upgrade software
1)
Start the CD Burning software and create a new CD project (Data Disc) with the following setting:
Label: DVP3XXX
(No need the label name)
File Name:
DVPXXXX_XX.BIN
Power on the set and open the tray, then press <option> to check the File Name.
Note: It is required capital letter for the File System name
2)
Burn the data onto a blank CDR
A.
Procedure for software upgrade:
1)
Power on the set and insert the prepared Upgrade CDR.
2)
The set will starts reading disc & response with the following display TV screen:
Upgrade file detected
VXX(SW VER )
<X>
<O>
3)
Press <OK> button to confirm, then screen will display :
Upgrade file detected
UPGRADING...
Do not power off...
4)
The upgraded tray will automatically open when files coping complete, then take out the disc.
5)
About 1 minute later, the trace will automatically close when upgrading complete.
B.
Read out the software versions to confirm upgrading
1)
Power on the set and press <Setup> button on the remote control.
2)
Press <Up><Next>< Up >< Up ><OK> button.
The software version and other information are display on the TV screen as follows:
Model
DVP3XXX_
File Name
DVPXXXX_XX.BIN
Version
XX.XX.XX.XX
8203RX
XX.XX.XX.XX
RISC
XXXXXX-XXX-XXX
Servo
XXXXX-XXX-XXXX
Region Code
X
Caution: The set must not be power off during
upgrading, Otherwise the Main board will be
damaged entirely.
3-1
Software upgrade
XX
Free Datasheet http://www.datasheet4u.net/
Advertisement
