Advertisement
Quick Links
Advertisement
Summary of Contents for Neets UniForm
- Page 1 Installation guide Neets Control - UniForm...
- Page 2 Thank you! Thank you for including the Neets Control - UniForm as part of your user experience strategy. For specifications, go to: www.neets.dk/uniform...
-
Page 3: Included In The Box
Included in the box... - Page 4 Front of controller E-paper Display Buttons Buttons 94 mm Mini USB Port 76 mm...
- Page 5 Back of controller Magnet TX-3 TX-2 Terminals TX-1 RX-1 I/O 3 I/O 2 I/O 1 Magnet Magnets LAN/PoE...
- Page 6 Recommended position The controller is designed to be mounted onto a wall in a vertical orientation. We recommend locating the center of the 165 cm / 65” controller between 145 cm – 165 cm (57” – 65”) above the floor depending on the height of your typical users..
-
Page 7: Bracket Details
Bracket details The controller is designed for mounting onto either a 1-gang electrical box based on EU standards or a DK 1,5M (LK FUGA Air only). It can also be mounted directly onto the wall without any electrical box. When using EU or DK electrical boxes, attach the mounting bracket by using the dedicated holes and screws for the specific type of electrical box that you have. -
Page 8: Mounting The Bracket
Mounting the bracket To mount the controller onto an electrical box, follow Step 1, which is illustrated on page 8 (DK) or 9 (EU). If you are not mounting onto an electrical box, skip ahead to Step 2 to 5, which are shown on page 10 . - Page 9 Mounting onto a DK 1,5M electrical box (LK FUGA Air)
- Page 10 Mounting onto an EU 1-gang electrical box...
- Page 11 Mounting directly onto the wall. Cutout in the wall must be at least 45 x 45 mm (1,8” x 1,8”)
-
Page 12: Powering The Controller
Powering the Controller Connect the PoE cable (and terminal connectors if they are a part of the installation) from the wall to the controller. From IEEE802.3 compliant PoE injector or switch... - Page 13 Mounting the Controller on the bracket Put the controller on top of the bracket. Make sure the controller is lined up correctly and ensure that the alignment holes are free so that all four magnets are able to connect. To remove the controller, use both hands to grasp the controller on each side and pull it straight out from the wall.
- Page 14 Uploading a Project File First, connect the controller to your PC using a USB cable. Now, using the Neets Project Designer software, you can upload a projectfile directly to the controller. For more information about Neets Project Designer, visit: www.neets.dk/product/neets-...
- Page 15 The Class A limits are designed to provide reasonable protection against harm- dangerous voltage or other hazards. Contact your local Neets reseller or ful interference when the equipment is operated in a commercial environment.
- Page 16 Learn more at neets.dk Visit our website neets.dk for additional information about the product and the latest firmware. Neets A/S | Langballe 4, 8700 Horsens, Denmark | +45 75 666 099 | sales@neets.dk | www.neets.dk...