Table of Contents
Advertisement
Disconnect the cable from the satellite dish LNB and connect it to the
4.
ComBIneD oUT port on the Combiner (SR2261) as shown. (Refer to
page 5 for the Combiner port identification.)
5.
Using one of the RG-6 cables which you purchased, connect it between
the satellite dish LNB and the DBS In port on the Combiner (SR2261) as
shown. (Refer to page 5 for the Combiner port identification.)
Combiner
6.
Disconnect the existing cable run from the multiswitch and connect this end
of the cable to the ComBIneD In port on the Splitter (SR2251) as shown.
(Refer to page 5 for the Splitter port identification.)
7.
Connect another of the RG-6 cables you purchased between the multi-
switch and the DBS TV port on the Splitter (SR2251) as shown. (Refer to
page 5 for the Splitter port identification.)
8.
Connect another of RG-6 cables you purchased between the SIRIUS oUT
port on the Splitter (SR2251) and the f connector end of the supplied RG-
174 Adapter cable as shown. (Refer to page 5 for the Splitter port identifica-
tion.)
9.
Connect the other end of the RG-174 Adapter Cable to the anT connection
on your SIRIUS radio as shown.
10.
Verify that the satellite TV receiver/tuner is plugged into a working AC out-
let. Next, connect the provided AC Power Adapter to the PoWeR In port of
the Splitter (SR2251), and plug it into a working AC outlet.
The installation is now complete.
Home Signal Distribution Kit Installation Guide
Step 6
Splitter
C
S
Step 10
Step 8
M
Step 7
Multiswitch
Step 9
1
Advertisement
Table of Contents
