Choke Knob - Kubota Z411 Operator's Manual

OPERATING THE ENGINE
(1) Parking brake pedal
(2) Parking brake lock pedal
3. Make sure that the PTO switch is in the
"DISENGAGED" (OFF) position.
(1) PTO switch
(A) "ENGAGED" (ON)
4. Place the motion control levers in the "NEUTRAL
LOCK" position.
(1) Motion control lever (LH)
(2) Motion control lever (RH)
(A) "NEUTRAL LOCK" position
(B) "NEUTRAL" position (held by
hands)
5. Set the throttle lever as follows.
Place the throttle lever midway between the
"SLOW" and the "FAST" positions.
28
(3) Right foot
(B) "DISENGAGED" (OFF)
(C) "FORWARD"
(D) "REARWARD"
(1) Throttle lever
(A) "FAST"
6. Set the choke knob to the "ON" position.

(1) Choke knob

(P) "PULL" (ON)
7. Insert the key into the key switch. Turn the key
switch to the "START" position and release the key
to the "ON" position when the engine starts.
(See Key switch on page 29.)
IMPORTANT :
• Because of the start interlocks, the engine
can not be started except when the PTO
switch is disengaged (OFF), the parking
brake is applied, motion control levers are in
"NEUTRAL LOCK" position and the operator
is sitting on the seat.
8. Warm up the engine by running at medium speed.
1. Choke knob
Pull the choke knob to engage the choke.
Push in the choke knob to disengage the choke.
When the engine is cold
Always engage the choke to start the engine in cold
conditions.
The engine and equipment may be operated during the
warmup period, but it may be necessary to leave the
choke partially on until the engine warms up.
STARTING THE ENGINE
(B) "SLOW"
(Q) "PUSH" (OFF)
Z400