Advertisement
nut) until there is
ail
rod with fingers
relation t o the rocker arm, the clearance
n u t should t h e n
plunger
With
following valves may be adjusted.
engine in this position. the following valves
I
is
made by backing off the adjusting nut (rocker arm stud
adjustment
in the valve push rod and then tightened to just
rocker
push rod to
arm clearance. This may be determined by rotating push
the nut is tightened. When rod does not readily move
a5
be tightened an additional
t h e
center of its
travel,
t h e
engine in the number 8 firing position as determined
one
revolution. This is number 3 firing
ha5
been eliminated.
turn to place the hydraulic lifter
No further adjustment i s required.
exhaust
intake
intake 1-5-6-8
exhaust 2-4-74!
may
be adjusted.
exhaust 7-4-3-2
intake
3
remove
T h e
adjusting
above, the
position.
With the
Advertisement
