Singer FW75 Instruction Book
  1. Manuals
  2. Brands
  3. Singer Manuals
  4. Sewing Machine
  5. FEATHERWEIGHT FW-75
  6. Instruction book
Singer FW75 Instruction Book

Singer FW75 Instruction Book

Singer sewing machine user manual
Hide thumbs Also See for FW75:
Table of Contents

Advertisement

Quick Links

Advertisement

Table of Contents
loading

Related Manuals for Singer FW75

Summary of Contents for Singer FW75

  • Page 4: Main Parts

    MAIN PARTS 1.Face Plate 2.Reverse Stitch Button 3.Slow Button 4.Start/Stop Button 5.Speed Control Lever 6.Extension Table (Accessory Case) 7.Bobbin Winder Tension disc 8.Needle Up/Down Button 9 10 04 05 26 27 37 38 48 49 59 60 9.Thread Tension Regulator 10.Spool pin 11.Bobbin winder Shaft 12.Bobbin Winder Stop...
  • Page 5 18.Carrying Handle 19.Thread guide for upper threading 20.Power switch 21.Air vent 22.Foot control plug 23.Plug socket 24.Power cord 25.Foot control 26.Lower thread guide 27.Needle threader lever 28.Needle threader 29.Buttonhole lever 30.Presser foot thumb screw 31.Needle plate 32.Bobbin cover 33.Bobbin cover release lever 34.Presser foot holder 35.Presser foot 36.Needle thread guide...
  • Page 6 ACCESSORIES Some accessories are provided in the accessory case. 1.Needle set 2.Bobbins 3.Spool pin cap (large) 4.Spool pin cap (small) 5.Straight stitch foot 6.Needle plate screwdriver 7.Screwdriver 8.Buttonhole opener with brush 9.Oiler 10.Buttonhole Foot 11.Overcasting Foot 12.Zipper Foot 13.Blind hem Foot 14.Satin Foot 15.Rolled hem Foot 16.Gathering Foot...
  • Page 7 a.REMOVING THE EXTENSION TABLE Hook your finger to the bottom of extension table and slid to the left. To attach, insert to the right. b.OPENING THE ACCESSORY CASE Hook your finger to the left side of accessory case and pull toward you. DUST COVER Cover the machine with dust cover when it is not in use.

  • Page 8: Changing The Presser Foot

    CHANGING THE PRESSER FOOT The presser foot must be changed according to the stitch you sew, or work you do. CAUTION:To prevent accidents. Turn off the power switch before you change the presser foot. 1.Turn the hand wheel toward you until the needle is at its highest point.
  • Page 9 CONNECTING THE MACHINE...

  • Page 11: Foot Controller

    FOOT CONTROLLER For this machine use foot controller type YSD 180034.

  • Page 13: Bobbin Winding

    BOBBIN WINDING REMOVING THE BOBBIN 1.Remove the slide cover by sliding the locker to right and push down the left corner of slide cover. At the same time. 2.Remove the bobbin from the machine. WINDING THE BOBBIN 1.Pivot spool pin into highest horizontal spool pin position. 2.Pass a spool of thread on the spool pin.
  • Page 14 INSERTING THE BOBBIN 1. Place bobbin into bobbin holder with the thread unwinding counter clockwise. 2. Draw thread into notch (A). 3. Pull thread toward the left and along the inside of spring (B) until it slips into notch (C) being sure that thread does not slip out of notch (A).

Table of Contents