Installation Overview; Warnings - Emerson Sensi Installation Manual

Installation Overview

CREATE YOUR ACCOUNT.
Open the Sensi app on your device and follow
the prompts to create an account, using a valid
email address.
Your Sensi account can only be linked to one
email address, but you can share your account
information across devices so your whole family
can have access.
INSTALL YOUR THERMOSTAT.
The Sensi app will walk you through removing your
old thermostat from the wall, labeling your existing
wires and installing your new Sensi thermostat.
CONNECT TO WI-FI.
After installation the app will walk you through
connecting your new thermostat to your home
Wi-Fi network. Remember to have your Wi-Fi
network name, password and Sensi
password ready.
REGISTER YOUR THERMOSTAT.
Finally, the app will walk you through registration
so you can start controlling your home comfort.
Anytime. Anywhere.
10

Warnings

INSTALLER INFORMATION
FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY
BEFORE INSTALLING OR OPERATING THIS CONTROL COULD
CAUSE PERSONAL INJURY AND/OR PROPERTY DAMAGE.
WARNING: OUT OF PHASE TRANSFORMERS
On two transformer systems, the transformers MUST be
in phase. Measure the voltage across RC and RH. If more
than 12 Volts AC is present between RC and RH, then the
transformers are NOT in phase.
To correct this condition, reverse the secondary
ow voltage connections at either the Heating or
Cooling transformer.
VOLTAGE REQUIREMENTS
Do not use on circuits exceeding specified voltage.
Higher voltage will damage control and could cause
shock or fire hazard.
Thermostat installation and all components of the control system
shall conform to Class II circuits per the NEC code.
11