Toshiba RAV-SM562CT-E Installation Manual page 26

8
APPLICABLE CONTROLS
Procedure example
While the operation stops, change the setup.
(Be sure to stop the operation of the unit.)
Procedure
Push simultaneously
shown below. Check the displayed ITEM CODE is [10].
• When the ITEM CODE is other than [10], push
erase the display and repeat procedure from the first step.
1
(After pushing
is not accepted for approx. 1 minute.)
(For a group control, No. of the firstly displayed indoor unit
becomes the header unit.)
Every pushing
unit of which setup is changed.
2
In this time, the position of the indoor unit of which setup is changed can be confirmed because fan and flap of
the selected indoor unit operate.
Using temp. setup
3
-1 ITEM CODE [12].
Using timer time
3
-2 from [3] to [2].
SET
Push button.
3
-3 In this time, the setup finishes when the display changes from
flashing to lighting.
Using temp. setup
4
-1 ITEM CODE [13].
Using timer time
4
-2 from [3] to [2].
SET
Push button.
4
-3
In this time, the setup finishes when the display changes from
flashing to lighting.
Using temp. setup
5
-1 ITEM CODE [14].
Using timer time
5
-2 [0001] to [0002].
(Setup data [Header unit: 0001] [Follower unit: 0002])
SET
Push button.
5
-3
In this time, the setup finishes when the display changes from
flashing to lighting.

Manual address setup procedure
3 4
-2, -2,
SET TEST
CL
+ + buttons for 4 seconds or more. After a while, the display part flashes as
TEST
button, operation of the remote controller
UNIT
button, the indoor unit No. in the group control is displayed in order. Select the indoor
/ buttons, specify
(ITEM CODE [12]: Line address)
/ buttons, change the line address
/ buttons, specify
(ITEM CODE [13]: Indoor address)
/ buttons, change the indoor address
/ buttons, specify
(ITEM CODE [14]: Group address)
/ buttons, change the setup data from
SET DATA SETTING TEST
UNIT No.
R.C. No.
TEMP.
5
-2
TIMER SET FAN
7
TIME SWING/FIX
FILTER
RESET TEST SET CL UNIT
1
Description
TEST
button to
Indoor unit No. before setup change is displayed.
Indoor unit No. before setup change is displayed.
Indoor unit No. before setup change is displayed.
23
7
CODE No.
ON / OFF
3 4
-1, -1,
MODE
2 6
VENT
,
3 4
-3, -3,
∗
SET DATA
SETTING TEST
UNIT No.
R.C. No.
∗
( Display changes according
to the model No. of indoor unit.)
SET DATA
SETTING TEST
UNIT No.
R.C. No.
SET DATA
SETTING TEST
UNIT No.
R.C. No.
SET DATA
SETTING TEST
UNIT No.
R.C. No.
SET DATA SETTING TEST
UNIT No.
R.C. No.
SET DATA
SETTING TEST
UNIT No.
R.C. No.
SET DATA SETTING TEST
UNIT No.
R.C. No.
5 6
-1,
5
-3
CODE No.
CODE No.
CODE No.
CODE No.
CODE No.
CODE No.
CODE No.