Message List - Sony PCS-3000 Operating Instructions Manual

Message List

Message
INCORRECT DIALING
SETUP
CANNOT COMPLETE
CONNECTION
(3-digit error message
appears)
USER BUSY
PLEASE GO TO MAIN
MENU TO ANSWER
CALL
COMMUNICATION
ERROR
(3-digit error message
appears.)
CANNOT ESTABLISH
ALL CONNECTIONS
MCU REJECTS
COMMAND
CORRUPTIVE DATA
STREAM, TERMINATE
THE CONNECTION
SOME OPERATIONS
INACTIVE
Message
AUTO RECEIVE CALL IN PROGRESS
MEETING STARTS!
MEETING ENDS
PLEASE WAIT
GRAPHIC IN TRANSMISSION
YOU ARE ON THE SCREEN
MEETING STARTS, T.120 READY
T.120 READY
The following messages appear on the TV monitor when using the PCS-
3000/3000P and gives instructions on dealing with them.
Message meanings and solutions
Meaning
Dialing was not successful because the
selected entry has not yet been registered or is
incorrectly registered.
The incoming or outgoing call is not connected.
The line is busy.
A call has come in without the MAIN or sub-
menu on the screen.
Error No. 132
The SPID registration is wrong.
Some connections were not completed.
The operation was rejected by the MCU.
A signal error occurred. The line connections
are compelled to be disconnected.
The remote camera control based on Sony
standard does not work:
The following messages indicate the state of the system. No action is
required.
Confirmation messages
The system, while in auto answer mode, has received an incoming call and is
connecting to the remote party.
Connection with the remote party has been completed, the meeting can now
begin.
Operations for ending the meeting have been completed.
Wait for a while the initialization is completed.
The still picture is being transmitted.
Local picture is being sent via the MCU.
The meeting has begun when T.120 is available.
T.120 has become available.
Solution
Make sure the selected entry is correctly
registered. See page 2-1.
See "Error number definitions and remedies"
on page A-8.
Dial again. See page 3-4.
Display the MAIN menu. See page 1-5.
Register the SPID setting correctly.
See page 2-15.
Check to see if your partner's telephone number
is the correct one.
See page 2-1.
The function is not supported for MCU if the
same operation displays this message again.
Dial again.
See page 3-4.
Dial again.
See page 3-4.
Meaning
A-7
Appendix