Making Of Ethernet Cables; Making Of Straight Through Ethernet Cables (Rj45; Making Of Straight Through Power Supply Ethernet Cables (C-Rj45-001; Table B.2-1 Connections Of Straight Through Ethernet Cables (Rj45 - Zte ZXR10 User Manual

W140a outdoor wireless access point/bridge. was (v1.0) ip wireless access system.
Hide thumbs Also See for ZXR10:
Table of Contents

Advertisement

ZXR10 WAS (V1.0) W140A Outdoor Wireless Access Point / Bridge User's Manual
transmission distance. So, in the wireless LAN system, no matter whether Ethernet
power supply is adopted, when the total wiring length (L) between the AP and Ethernet
switch is greater than 100m (less than 300m), it is suggested to configure the Ethernet
switch port as 100 M.
B.2 Making of Ethernet Cables
B.2.1 Making of Straight Through Ethernet Cables (RJ45)
In IP wireless access system, the following network cables must adopt the straight
through Ethernet cables:
1.
2.

Table B.2-1 Connections of Straight Through Ethernet Cables (RJ45)

End A
Signal Name
1
Data receiving Rx+
2
Data receiving Rx-
3
Data transmitting Tx+
4
MATCH1
5
MATCH2
6
Data transmitting Tx-
7
MATCH3
8
MATCH4
B.2.2 Making of Straight Through Power Supply Ethernet Cables (C-RJ45-001)
The Ethernet cable between the W201P (end A) and AP (end B) not only serves as the
Ethernet data signal cable, but also provides -48V DC power for two twisted pairs 4&5
and 7&8 on the load balance, to power AP remotely.
The connection method of this cable is the same as that of the straight through cable
without power supply, and the connection table is shown in Table B.2-2.
The Ethernet cable between the Ethernet switch (end A) and W201P (end B).
If no switch is used, the AC downlink port is directly connected to W201P, and
the Ethernet cable between AC (end A) and W201P (end B) is a straight through
Ethernet cable.
The connections of the straight through Ethernet cables are shown in Table
B.2-1.
Conductor Color
White/orange
Orange
White/green
Blue
White/blue
Green
White/brown
Brown
End B
Signal Name
1
Data transmitting Tx+
2
Data transmitting Tx-
3
Data receiving Rx+
4
MATCH1
5
MATCH2
6
Data receiving Rx-
7
MATCH3
8
MATCH4
B-2
Conductor Color
White/orange
Orange
White/green
Blue
White/blue
Green
White/brown
Brown

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents