Supplying Power - ABB Totalflow microFLO G4 Startup Manual

3D Reinstall the terminal block with the wires attached. Secure the
cable to the meter run pipe with the plastic tie-wraps. Do not
wrap the cable around the meter run pipe.

Supplying Power

The user has two powering options with the µFLO
External. Steps 4 and 5 detail the Battery/Solar option. Step 6 details the
external scenario.
Step 4 Battery Pack
A battery pack provides the µFLO
is packed and shipped separately. Before installation, inspect the power
cables where they terminate on the battery pack and the connectors for
breakage.
4A Open the µFLO
the compartment. Ensure that the battery terminals are not
touching either the keeper lip on the shelf or any metal surface
inside of the unit.
4B Connect the battery pack connector to the µFLO
battery connection, J15. Verify that the jumper at J16 is across
pins 1 & 2 (default). Observe the LCD. Verify the LCD is on
and scrolling through the diagnostics sequence.
4
G4
with its operating power. The battery
G4
's hinged door. Insert the battery pack into
G4
: Battery/Solar or
G4
board's