Table of Contents
Advertisement
STEP 3: Setup your computers for networking
For each computer, you connect to the Router you must make the
correct network settings. Belkin has simplified this process by
providing you with the Belkin SOHO Networking software to
configure your computers. Follow the steps below to install this
software on your computers.
Installing the Belkin SOHO Networking Software
1. Insert the CD-ROM that came with the Belkin 4-Port Cable/DSL
Gateway Router into your CD-ROM drive of your computer
connected to LAN Port-1.
2. Double-click on "My Computer" then double-click on your
CD-ROM drive. Double-click on the icon called "Install" in the
CD-ROM window.
3. Windows will install the software onto your PC. Follow the
directions on the screen to complete the installation. After the
Belkin SOHO Networking Software is installed, Windows may ask
you to restart your computer. If so, please do so.
4. Repeat these steps for each computer you are connecting to
your network.
5. Once you have installed the Belkin SOHO Networking Software
on all of your computers, continue on to the next section.
Configuring Your Computers Using Belkin NetSetup
1. Once your computer has restarted, click "Start", "Programs",
"Belkin SOHO Networking" then "Belkin NetSetup" to launch this
easy-to-use computer configurator.
Step 3
14
Advertisement
Table of Contents
