Download Print this page
Hughes & Kettner RED BOX 5 Manual
Hughes & Kettner RED BOX 5 Manual

Hughes & Kettner RED BOX 5 Manual

Guitar cabinet simulator

Advertisement

Quick Links

Version 1.0
The Hughes & Kettner RED BOX 5 converts line and speaker signals sourced
from guitar amps into balanced, frequency-compensated, microphone-level
signals with tonal characteristics of a 4 x 12" cabinet. It lets you feed a
guitar amp's speaker out, line out or FX send straight into a mixing console's
microphone input.
Note: The RED BOX 5 emulates the speaker, not the microphone. In other words,
signals provided by the RED BOX 5 sound like those of an actual cab rather than
that of a microphone picking up the sound of a cab. The benefits are considerable:
You get a fatter, punchier and more direct signal with far greater presence,
bandwidth and dynamic range than signals captured with a microphone. With the
RED BOX 5, you can take the PA and playback device out of the sonic equation
and deliver the sound of a guitar cabinet straight to audiences and listeners. Best
of all, there's no latency, spillover or crosstalk from other signal sources such as
drums, frequency cancellations caused by neighboring microphones or any danger
of feedback.
This signal is the best you can get for processing with compressors, equalizers,
reverb effects and microphone simulations on stage and in the studio.
Tip: Experimentation is very much encouraged: Make the most of both worlds
by mixing the signals from the RED BOX 5 and a microphone. The RED BOX 5
lends every microphone signal more girth and presence without detracting from its
inherent characteristics.
Connections
The RED BOX 5 provides one unbalanced ¼" (6.3 mm) jack input (IN) for line and
speaker signals and two different outputs: One unbalanced ¼" (6.3 mm) jack (THRU)
lets you patch through the unprocessed signal. One balanced XLR connected lets
you feed the processed signal to a mixing console. Note that some mixing consoles
do not provide phantom power. In that case, the RED BOX 5 is ready for an optional
power supply (see Technical Specifications) and comes with a compartment
accommodating a 9 V battery (unscrew the feet to open the housing).

Advertisement

loading

Summary of Contents for Hughes & Kettner RED BOX 5

  • Page 1 Note that some mixing consoles do not provide phantom power. In that case, the RED BOX 5 is ready for an optional power supply (see Technical Specifications) and comes with a compartment...
  • Page 2: Control Features

    RED BOX 5 via a battery or optional power pack! Control features The RED BOX 5 features the usual Ground Lift switch and Pad switch to adjust input gain. There are also three sliding switches that provide some unusual sound-shaping filters.
  • Page 3 1) The combo provides a separate jack for connecting external speakers alongside the built-in speaker, and the jack for the external speaker DOES NOT switch off the internal speaker. In this case, connect RED BOX 5’s input (IN) to the external speaker out and do not use the THRU jack.
  • Page 4: Technical Specifications

    amplifiers. However, the speaker output, ideally with a loudspeaker connected, will provide better tone because solid-state power amps also influence speakers’ frequency response. Technical Specifications Input: Unbalanced ¼" (6.3 mm) jack 0 dB: Impedance 10 kΩ Max. input gain (+9 V battery) +10 dBV Max.