Pentair Pool Products RF2000 Instructions For Use

INSTRUCTIONS
RF2000 Transmitter and Receiver
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Modifications not expressly approved by the party responsible for FCC compliance could
void the user's authority to operate the equipment.

Installation Instructions

1. Set the local address code in the receiver by switching dipswitches 5 and 6 inside of
the receiver. The default channel is Channel 1.
1. Turn power switch and colorwheel switch on the side of the PG2000 unit to OFF.
2. Remove PG2000 body.
3. Very Carefully straighten out the antenna on the receiver module.
4. Place receiver module on the left side of the unit next to the ballast. Look for the ribs
as a guide. The 4 pin plug should face the back of the unit and the antenna should face
forward. Use the double sided foam tape to hold the receiver in place
5. Plug the 4 pin connector from the PG2000 into the 4 pin connector from the RF2000.
The plug coming out of the RF2000 basically does a U turn and heads toward the
PG2000 plug. You may have to shift the receiver module around a bit to get your hands
in to make the connection
6. Drape the antenna forward into the fiber conduit area. It should stay on the outer
perimeter of this area curving around to the front of unit. Keep the antenna as straight as
possible.
Rev X1 Pentair Pool Products, Inc. P/N 840316
Sanford NC
Moorpark CA