Using Batteries; Setting The Battery Type - Yamaha Sonogenic SHS-500 Owner's Manual

Using Batteries

This instrument requires six "AA" size, Alkaline (LR6)/ Manganese (R6) batteries, or rechargeable
nickel-metal hydride batteries (rechargeable Ni-MH batteries).

Setting the battery type

Depending on the battery type to be used, you may need to change the battery type setting on this
instrument. To change the setting, first turn on the power to the instrument, then choose the battery
type you would like to use. Alkaline and manganese batteries are chosen by default. Press the
[FUNCTION] button repeatedly to select "Battery," then rotate the [SELECT] knob to select the
battery type "Alkaline" (Alkaline and manganese batteries) or "Ni-MH" (rechargeable Ni-MH
batteries).
NOTICE
Failure to set the battery type may shorten the amount of the battery life. Make sure to set the battery type
correctly.
1.
Make sure that the power of the instrument is off.
2.
Open the battery compartment cover located on the instrument's bottom panel.
3.
Insert the six new batteries, being careful to follow the polarity markings on the
inside of the compartment.
4.
Replace the compartment cover, making sure that it locks firmly in place.
NOTICE
• Connecting or disconnecting the power adaptor with batteries installed may turn the power off,
resulting in loss of data.
• When battery power becomes too low for proper operation, the volume may be reduced, the sound
may be distorted, and other problems may occur. When this happens, make sure to replace all
batteries with new ones or already recharged ones.
NOTE
• This instrument cannot be used to charge the batteries. Use only the specified charger device when
charging.
• Power will be automatically drawn from the AC adaptor if an AC adaptor is connected while batteries are
installed in the instrument.
18
SHS-500 Owner's Manual