Table of Contents
Advertisement
4
Maintaining the display
Maintenance guidelines
To enhance the performance and extend the life of the display:
Do not open the display cabinet or attempt to service this product yourself. Adjust only those controls
●
that are covered in the operating instructions. If the display is not operating properly or has been
dropped or damaged, contact an authorized HP dealer, reseller, or service provider.
Use only a power source and connection appropriate for this display, as indicated on the label/back plate
●
of the display.
Be sure the total ampere rating of the products connected to the outlet does not exceed the current
●
rating of the AC outlet, and the total ampere rating of the products connected to the cord does not
exceed the rating of the cord. Look on the power label to determine the ampere rating (AMPS or A) for
each device.
Install the display near an outlet that you can easily reach. Disconnect the display by grasping the plug
●
firmly and pulling it from the outlet. Never disconnect the display by pulling the cord.
Turn the display off when not in use. You can substantially increase the life expectancy of the display by
●
using a screen saver program and turning off the display when not in use.
NOTE:
Slots and openings in the cabinet are provided for ventilation. These openings must not be blocked or
●
covered. Never push objects of any kind into cabinet slots or other openings.
Do not drop the display or place it on an unstable surface.
●
Do not allow anything to rest on the power cord. Do not walk on the cord.
●
Keep the display in a well-ventilated area, away from excessive light, heat or moisture.
●
When removing the display stand, you must position the display facedown on a soft area to prevent it
●
from getting scratched, defaced, or broken.
Cleaning the display
1.
Turn off the display.
2.
Disconnect any external devices.
3.
Dust the display by wiping the screen and the cabinet with a soft, clean antistatic cloth.
IMPORTANT:
points of entry can cause damage to the display. Allow the unit to air-dry before use.
4.
Next, use any of the following germicidal wipe formulations to safely disinfect all exposed surfaces of
your display. Refer to the directions for use provided by the manufacturer of the wipes.
IMPORTANT:
Never spray the cleaner directly on the screen surface. It may run behind the bezel and damage the
electronics.
28
Chapter 4 Maintaining the display
A burned-in image on the display screen is not covered under the HP warranty.
The cloth should be moist, but not wet. Water dripping into the ventilation or other
Spray the cleaner onto a cloth and use the damp cloth to gently wipe the screen surface.
Hide quick links:
Advertisement
Table of Contents
