Level 3 (Input Level) - Taie FA Series Operation Manual

9.3

LEVEL 3 (Input Level)

To enter level 3 , set LCK to "0000"and then press SET key + Shift(
Input type selection
Set
Analog input low limit calibration
(Used for mA and V input)
Set
Analog input high limit calibration
(Used for mA and V input)
Set
Decimal point position
(Available for mA and V input)
Set
Lower Set-Point Limit
Set
Upper Set-Point Limit
Set
Remote input low limit calibration
Set
Remote input high limit calibration
Set
Alarm mode of AL1
Set
Alarm time of AL1
Set
Alarm mode of AL2
Set
Alarm time of AL2
Set
Alarm mode of AL3
Set
Alarm time of AL3
Set
Hysteresis of all Alarm
Set
Output 1 low limit calibration
(Used for mA and V output)
Set
Output 1 low limit calibration
(Used for mA and V output)
Set
Range：-1999 ~ 9999
Range：0 ~ 9999
0000，000.0，00.00，0.000
Scaling Low Limit
Scaling High Limit
Range：-1999 ~ 9999
Range：0 ~ 9999
Range:00~19
Refer to "Alarm mode type＂
Range：0~99 Min 59 Secs
0=Flicker Alarm，99:59=Continued
Others=On delay time
(If ALD=07 , ALT means alarm on time)
The same with ALD1
The same with ALT1
The same with ALD1
The same with ALT1
Range：0~1000
Range：0 ~ 9999
Range：0 ~ 9999
28
) key 3 seconds.