Samsung SM-T820 User Manual page 108

Health and safety information
Exposure to Radio Frequency (RF) Signals
Your wireless device is a radio transmitter and receiver.
It is designed and manufactured not to exceed the
exposure limits for radio frequency (RF) energy set by
the Federal Communications Commission (FCC) of the
U.S. government. These FCC exposure limits are derived
from the recommendations of two expert organizations,
the National Counsel on Radiation Protection and
Measurement (NCRP) and the Institute of Electrical
and Electronics Engineers (IEEE). In both cases, the
engineering experts drawn from industry, government,
The exposure limit set by the FCC for wireless mobile
devices employs a unit of measurement known as the
the rate of absorption of RF energy by the human body body ody
expressed in units of watts per kilogram (W/kg). The FCC . The FCC The FCC
requires wireless devices to comply with a safety limit y limit y limit
of 1.6 watts per kilogram (1.6 W/kg). The FCC exposure exposure osure
limit incorporates a substantial margin of safety to give afety to give give
additional protection to the public and to account for to account for
any variations in measurements.
SAR tests are conducted using recommended operating ommended operating mended operating
positions accepted by the FCC with the FCC with the
tested frequency bands. Although the SAR is determined Although though the SAR is determined the SA
of the whi e operating can be we l below the e operating can be we e operating can be we l b l below the
maximum value. This is because the This This is because the is bec is is designed is designed
to operate at multiple power levels so as to use only the multip multiple power levels so as to use only the le power levels so as to use
power required to reach the network. In general, the uired to reach the network. In general, the uired to reach the network. In gen
closer you are to a wireless base station antenna, the ou are to a wireless base station antenna, the ou are to a wireless base station ant
lower the power output. r the power output. r the powe
Before a new model device is available for sale to the efore a new model device is a new mod av v ailable for sale to the ailable for sale to the
it does not exceed the it does not exceed the exposure limit established by exceed the exposur xposure limit established by e limit established by
the FCC. Tests for each model are per ormed in the FCC. Tests for each model are per or each model are ormed in
positions and locations (e.g. n positions and locations (e.g. near the body) positions and locations (e.g. near the body) as required as required
b by the FCC. b y the FCC y the FCC.
For typical operations, this model has been For typical operations, this mode operations, this mo
tested and meets the FCC exposure guide tested and meets the FCC exposure guidelines. eets the FCC expo
for
SAR information on this and SAR information on this and o SAR information on this and other model can
be be be viewed on-line at http://www.fcc.gov/oet/ea/fccid/. viewed vie on-line line at http:// at http://
This site uses the FCC ID number This Thi site uses the FCC ID D
You can check the FCC ID on the rear case. You can check the F
Once you have the FCC ID number for a particular Once you have th
follow the instructions on the website and it should follow the inst
provide values for typical or maximum SAR for provide val
a particular a particu
SAR information can also be obtained at www.fcc.gov/ SAR in
c cgb/sar. cgb
Operating Environment
l has been
Remember to follow any special regulations in force in
any area and always switch your
forbidden to use it, or when it may cause interference or
danger. When connecting the
another device, read its user's guide for detailed safety
instructions. Do not connect incompatible products.
A3LSMT820.
,
or any a cessor to