Installing The Lcd Color Tv On The Wall - Sharp AN-52AG1 Operation Manual

Installing the LCD color TV on the wall

• Be sure to use at least 2 people when installing the LCD color TV to the based bracket.
Caution
• Be sure to perform Steps 1 and 2 below. Only performing Step 1 could result in the display
falling and injuring someone.
Install the main bracket unit attached to the LCD color TV to the
1
based bracket.
The protruding pins of the main bracket unit catch on the slots on both sides of the wall-
mount bracket.
At this time, fit the pins at the upper most position on the sides of the main bracket unit into
the slots that match the wall-mount bracket connection lever marks (color marks) set to that
height in the procedure on the previous page.
Use the screws to fasten the main bracket unit and the wall-mount
2
bracket connection levers. (Be sure to do this.)
*To change the angle from the currently set angle position, refer to the explanation on page 8
"Adjusting the Angle of Bracket Unit A" before conducting the assembly work.
*When setting it to the vertical (0°) position, use all 4 of the screws removed in accordance
with the instructions on page 7 "Adjusting the Angle of Bracket Unit A."
LCD television
Wall
(Green)
+5
(Yellow)
0
-5
(Blue)
Check the protruding pin slots.
+5
0
-5
E-13