Managing The Asa Firepower Module; Install Or Reimage The Module - Cisco ASA Series Configuration Manual

Chapter 7 ASA FirePOWER Module
Example:
hostname(config)# interface gigabitethernet 0/5
Remove any name configured for the interface. If this interface was used in any ASA configuration, that
Step 2
configuration is removed. You cannot configure traffic-forwarding on a named interface.
no nameif
Enable traffic-forwarding.
Step 3
traffic-forward sfr monitor-only
Note
Enable the interface.
Step 4
no shutdown
Repeat for any additional interfaces.
Examples
The following example makes GigabitEthernet 0/5 a traffic-forwarding interface:
interface gigabitethernet 0/5
no nameif
traffic-forward sfr monitor-only
no shutdown

Managing the ASA FirePOWER Module

This section includes procedures that help you manage the module.
•
•
•
•
•
•
•
•

Install or Reimage the Module

This section describes how to install or reimage a software or hardware module.
•
You can ignore any warnings about traffic forwarding being for demonstration purposes only.
This is a supported production mode.
Install or Reimage the Module, page 7-13
Reset the Password, page 7-18
Reload or Reset the Module, page 7-18
Shut Down the Module, page 7-19
Uninstall a Software Module Image, page 7-19
Session to the Software Module From the ASA, page 7-20
Reimage the ASA 5585-X ASA FirePOWER Hardware Module, page 7-16
Upgrade the System Software, page 7-20
Install or Reimage the Software Module, page 7-14
Managing the ASA FirePOWER Module
Cisco ASA Series Firewall CLI Configuration Guide
7-13