Advertisement
ASSEMBLY INSTRUCTIONS
4. Make connections on the back side of the fixture.
Connect the supply lead wires from the electrical box
to the fixture lead wires using the wire nuts (AA). The
black lead from the fixture (A) is spliced to the black
supply lead, and the white lead from the fixture (A) is
spliced to the white supply lead. Ensure the wire nuts
(AA) are tight. Wrap electrical tape around the wire
nuts (AA) to prevent them from coming loose.
Carefully push the spliced wires back into the electrical
box.
Hardware Used
AA
Wire Nut
5. Position the fixture over the electrical box so that the
threaded tube (DD) attached to the mounting bracket
passes through the mounting hole in the fixture.
Carefully, hand tighten the mounting cap (FF) and
secure the fixture to the mounting bracket, while
leveling up the fixture during the tightening process.
Ensure the fixture is level prior to fully tightening it
firmly against the surface. Overtightening the fixture
could result in damage to the fixture.
Hardware Used
FF
Mounting Cap
6. In the event of outdoor installation, a silicone or other
waterproof sealant around the outer perimeter of the
fixture (A) is needed to prevent water from seeping
into the wiring compartment.
4
3
x 2
5
x 1
6
2
4
AA
AA
DD
FF
FF
A
Lowes.com
A
Advertisement
