DeLonghi TRRS0715ECA Instructions For Use Manual page 12

SAVE THESE
INSTRUCTIONS
THIS PRODUCT IS FOR HOUSEHOLD USE
DESCRIPTION
A display
B on-standby button
C increase button
D
decrease button
E
power button
F
eco button
G
timer button
H
cord holder
I
wheel
USE
"Easy wheel" system
Turn the radiator upside down on a rug or a soft surface in
order to prevent damaging the paint finish.
Fully unfold the wheels by turning them outwards (Fig. 1).
Turn the radiator back to its upright position.
Fig. 1
Location
The heater must not be placed immediately below a power
outlet. Do not use this radiator in rooms having a surface area
of less than 43 square feet (4 sq.m.).
Power connection
- Before using the appliance check that your supply volt-
age is the same of that shown on the rating label of the
unit and that the power socket and power supply line
correspond to the load specified.
- Check also the current capacity of your fuses. CONNECT
YOUR HEATER TO EARTH PROVIDED SOCKET ONLY.
- This appliance complies with directive 2004/108/ec on
electromagnetic compatibility.
Plug in the heater, the appliance will be set in the stand-by
condition. The display will show the
clothing or bedding, furniture and flammable material away
from the power outlet where the heater is plugged in. After
ONLY
symbol. Keep loose
an interruption of the power supply (power failure or appli-
ance unplugged) the unit goes always to stand-by.
Heating function
To turn the appliance on, press the
Press button (E) to set the required power level:
MIN ( ); MED (
sired temperature, press button + or - (C or D). By pushing
the + or - button once, the temperature (shown on the dis-
play) will increase or decrease by 1°C (34°F). Keeping the + or
- button depressed the value will increase o decrease rapidly.
The appliance allows to set the temperature from 5°C (41°F)
to 28°C (82°F).
Anti-freeze function
Setting the temperature to 5°C (41°F) with the "-" button,
the appliance will activate the Antifreeze function.
The display will show the
ance will turn on automatically, at the max power, only if
the room temperature falls below 5°C (41°F). If you wish to
go back to the Heating function, press the "+" button once.
After an interruption of the power supply (probe failure or ap-
pliance unplugged) the unit goes always to stand-by.
Eco function
When this function is active the appliance automatically sets
the most appropriate power level to guarantee optimum
comfort while reducing energy consumption.
To activate this function press the "ECO" (F) button. The dis-
play will show
much higher than the actual room temperature, the appli-
ance will start automatically and rapidly to heat the room.
The appliance will automatically select the most convenient
power level (MAX-MED-MIN-OFF).
If MAX power level has been selected using the
ton, the appliance will cycle between: MAX-MED-MIN-OFF.
If MED power level has been selected, the appliance will cycle
between: MED-MIN-OFF.
If MIN power level has been selected, the appliance will cycle
between: MIN-OFF.
12
(B) button.
); MAX ( ). To select the de-
symbol, in this way the appli-
symbol. If the selected temperature is
but-