Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Ryobi RWL350-G
Summary of Contents for Ryobi RWL350-G
- Page 1 ORIGINAL INSTRUCTIONS Wood Lathe RWL350-G...
- Page 2 Important! It is essential that you read the instructions in this manual before assembling, operating, and maintaining the product. Subject to technical modification.
- Page 3 Safety, performance, and dependability have been given top priority in the design of your wood lathe. Do not abuse the cord. Never use the cord for carrying, pulling or unplugging the power tool. Keep cord away from heat, oil, sharp edges or INTENDED USE moving parts.
- Page 4 it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. switch off the product and disconnect from power supply before: Disconnect the plug from the power source and/ opening the door and changing speed. or remove the battery pack, if detachable, from the power tool before making any adjustments, adjusting or attaching the faceplate.
- Page 5 Authorised Ryobi Service Centre. Never stand on the product. Serious injury could occur wires, and any foreign objects. the product where anyone might stand on the product to reach it. and other conditions which can cause it to be thrown always disconnect the product from the power supply out of the lathe.
- Page 6 gouge in the opposite direction, which will carry the cut to will cause a loss of power and the motor will overheat. If the end of the spindle. tool does not operate when plugged into an outlet, double SPEED AND WIRING The speed of the product is not constant and decreases Cutting coves under a load or with lower voltage.
- Page 7 SYMBOLS IN THIS MANUAL WARNING For greater safety and reliability, all repairs should be Connect to power outlet. performed by an Authorised Ryobi Service Centre. ENVIRONMENTAL PROTECTION Recycle raw materials instead of disposing of as waste. The machine, accessories, and Parts or accessories sold separately friendly recycling.
- Page 8 Warning The following signal words and meanings are intended to DANGER Indicates an imminently hazardous situation, which, if not avoided, will result in death or serious injury. WARNING Indicates a potentially hazardous situation, which, if not avoided, could result in death or serious injury. CAUTION Indicates a potentially hazardous situation, which, if not avoided, may result in minor or moderate injury.
- Page 11 KNOW YOUR PRODUCT 2. Alignment adjusting screw Gouge 4. Tool rest Motor pulley 7. Hand wheel Spindle pulley Hand wheel handle Belt Faceplate Speed adjusting screws 20. Micro switch...
- Page 12 B C D A: 2480 min B: 1700 min C: 1180 min D: 850 min...
- Page 15 p.14 p.18 p.26 p.22 p.23 p.24 p.27...
- Page 31 PRODUCT SPECIFICATIONS REPLACEMENT PARTS Hand wheel Wood lathe Model Hand wheel handle Belt Input Power Speed Clamping capacity Faceplate Maximum diameter (260mm with drive centre and tool rest) Net weight Measured values determined A-weighted sound pressure level = 77.72 dB(A) Uncertainty K 3 dB(A) Measured values determined...
- Page 32 Imported by: Techtronic Industries Australia Pty Ltd Melbourne, Australia Techtronic Industries N.Z. Limited...