SkyLink GG-318 Installation, Programming And Operation Instructions

3-Button Remote
1. INTRODUCTION
Thank you for your purchase of Skylink® remote transmitter,
Model GG-318.
The following items are included in this package:
- One of GG-318 Remote
- Lithium Battery CR-2032 (Installed)
- Mounting accessories
-
Follow one or more instructions below to program transmitter GG-318 to the Skylink® receiver
or Skylink® garage door opener you want to control.
2. PROGRAMMING
2a. PROGRAMMING A REMOTE TRANSMITTER TO THE SKYLINK® GARAGE DOOR
OPENER ATOMS
1. Connect the opener to an approved power source.
The dot in the LED display stays on.
2. Press the [Set] button for one second, and release the
3. Within 30 seconds, press any button on the remote
that you would like to program to the opener.
Note:
. ..
[ ] = Button 1, [
4. Once the button on the remote is programmed. The
LED segment will off and emits one beep indicating
the programming successfully
MODEL: GG-318
SERIES
] = Button 2, [
Button
] = Button 3
Preliminary Copy
1 3
2