Download Print this page

Coaxial Cable; Mounting Antenna To Mast; Lightning Protection For Tv Antenna; Installing Coaxial Cable - Winegard HD7698P Instruction Manual

High definition vhf/uhf antennas

Advertisement

STEP 8 - Coaxial Cable
A. Slide the rubber boot over the end of the coaxial cable.
B. Attach the F-connector to the coaxial cable.
C. Attach the coaxial cable to the cartridge housing.
See FIGURE 8.
D. Slide the boot over the boot collar on the housing.
NOTE: If your coax cable has factory connectors on it, clip
small end of boot off, so boot will slip over connector.
STEP 9 - Mounting Antenna to Mast
A. Loosen nuts on the main boom and boom brace
mast clamps. See FIGURE 9.
B. Slide both mast clamps over the mast, pointing the
front of the antenna (small end) towards stations and
tighten the boom brace mast clamp securely.
C. Let the main boom mast clamp slide down the mast
until the boom brace supports the main boom. Tighten
the main boom and brace mast clamps securely.
D. To prevent wind whipping, the 75 ohm coaxial cable
downlead may be secured to the mast with tape or
plastic wire ties.

Lightning Protection for TV Antenna

A. Mount the lightning arrestor or 75 ohm coaxial
grounding block as close as possible to where the
75 ohm coaxial cable downlead enters the house.
B. The ground wires for both the mast and the
downlead should be copper or aluminum wire,
number eight or larger.
C. The downlead wire from the antenna to the lightning
arrestor and the mast ground wire should be secured
to the house, spaced four to six feet apart.
NOTE: In the case of a "ground up" antenna installation, it
may not be necessary to ground the mast if the mast extends
four or more feet into the earth. Consult a TV serviceman for
the proper depth in your location.
Winegard Company warrants this Winegard product against any defects in materials or workmanship within 90 (ninety) days from date of purchase. No warranty claim will be honored unless at the
time the claim is made, you present proof of purchase to an authorized Winegard dealer (if unknown, please contact Winegard Company, 3000 Kirkwood Street, Burlington, IA 52601-2000, Telephone
800-288-8094).
Winegard Company (at its option) will either repair or replace the defective product at no charge to you. This warranty covers parts, but does not cover any costs incurred in removal, shipping or
reinstallation of the product. This limited warranty does not apply if the product is damaged, deteriorates, malfunctions or fails from: misuse, improper installation, abuse, neglect, accident, tampering,
modification of the product as originally manufactured by Winegard, usage not in accordance with product instructions or acts of nature such as damage caused by wind, lightning, ice or corrosive
environments such as salt spray and acid rain.
The 90 Day Warranty is provided on the condition that the equipment is properly delivered with all handling and freight charges prepaid to your Winegard dealer for return to our factory for repair or
replacement. Winegard dealers will arrange for the replacement or repair and return to you without charge the product which failed due to defective material or workmanship.
WINEGARD COMPANY WILL NOT ASSUME ANY LIABILITIES FOR ANY OTHER WARRANTIES, EXPRESS OR IMPLIED, MADE BY ANY OTHER PERSON.
ALL OTHER WARRANTIES WHETHER EXPRESS, IMPLIED OR STATUTORY INCLUDING WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE AND MERCHANTABILITY ARE LIMITED
TO THE 90-DAY PERIOD OF THIS WARRANTY.
The foregoing shall be the sole and exclusive remedy of any person, whether in contract, tort or otherwise, and Winegard shall not be liable for incidental or consequential damage or commercial loss,
or from any other loss or damage except as set forth above.
Some states do not allow limitations on how long an implied warranty lasts, or the exclusion of limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you.
This warranty gives you specific legal rights and you may also have other rights which vary from state to state.
Winegard Company • 3000 Kirkwood Street • Burlington, IA 52601 • 1-800-288-8094 • Fax 319-754-0787 • www.winegard.com
Set
&
90 DAY LIMITED WARRANTY
Printed in U.S.A. © Winegard Company 2007 Rev5 11-16 1450292
FIGURE 8 - Installing Coaxial Cable
Attach coaxial cable with boot
FIGURE 9 - Mast Clamp
Mast Clamp
Insert
U-Bolt
LIGHTNING PROTECTION - Example of Antenna
Example of antenna grounding as per
Grounding (as per National Electrical
National Electrical Code, ANSI/NFPA 70
Code, ANSI/NFPA 70)
Electric
Service
Electric
Equipment
Service
Equipment
NEC – Nation Electrical Code
Hex Nuts
Mast Clamp
Antenna Lead
Antenna
In Wire
Downlead Wire
Ground
Ground
Clamp
Clamp
Antenna Discharge Unit
(NEC Section 810-20).
May substitute a 75 ohm
coax grounding block
Antenna
Discharge Unit
(NEC Section 810-20)
(May substitute a 75 ohm
Grounding
Coax Grounding Block)
Conductors (NEC
Grounding Conductors
(NEC Section 810-21)
Section 810-21)
Ground
Ground Clamp
Clamps
Power Service Grounding
Power Service Grounding Electrode System
Electrode System
(NEC Art 250, Part H)
(NEC Art 250, Part H)
NEC - National Electrical Code
Rev. 2/08

Advertisement

loading

This manual is also suitable for:

Hd8200u