Disassembly & Reassembly - Samsung SyncMaster 800TFT Service Manual

3 Disassembly and Reassembly
This section of the service manual describes the disassembly and reassembly procedures for the
SyncMaster 800TFT TFT-LCD monitor.
WARNING: This monitor contains electrostatically sensitive devices. Use caution when handling
these components.
3-1 Disassembly
Cautions:1. Disconnect the monitor from the power source before disassembly.
2. Follow these directions carefully; never use metal instruments to pry apart the cabinet.
3-1-1 Removing the Stand
1. Remove 4 screws on the Stand.
3-1-2 Main Body Disassembly
1. Remove 4 screws on the Rear Cover.
2. Pull the Rear Cover up and off the monitor.
3. Remove 4 screws on the BRKT-VESA and
Remove the BRKT-VESA.
4. Remove 16 screws on the PCB Shield and
remove the Shield.
5. Remove 7 screws on the Main PCB and 2
screws on the Inverter PCB and 2 screws on
the 10P Harness.
6. Disconnect the connector (140P) between the
Panel and the CN600 connector on the Main
PCB.
3-2 Reassembly
Reassembly procedures are in the reverse order of Disassembly procedures.
SyncMaster 800TFT
7. Disconnect the Function PCB wire (10P)
between the Function PCB and the CN102
connector on the Main PCB.
8. Disconnect 2 Inverter wires between the Panel
and the CN2, CN3 connectors on the Inverter
PCB.
9. Disconnect the 12P harness between CN1
connectors on the Inverter PCB and CN103
connector on the Main PCB.
10. Carefully lift the Main PCB Assembly and
Inverter PCB and place them on a flat, level
surface that is protected from static electricity.
11. Remove 10 screws on the PCB Bracket.
12. Remove the Bracket Assembly from the Front
Cover.
13. Remove the 2 screws on the Function PCB
from the Front Cover and remove the
Function PCB and Function Knob.
3-1