Advertisement
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
Do not bump or shock the tool when applying
it to any work piece. Rough treatment may
damage the highly sensitive mechanism.
Note: There are many applications for the Digital
Indicator. The following is one example of how this
product can be used: testing brake rotors for true.
1. Clean off all brake components with
brake parts cleaner before testing.
2. Push the "On/Off" Button (see Figure
A) to turn the meter "ON".
3. Clamp the Indicator (clamp sold separately) in place
so that only the needle contacts the brake rotor.
Push the Zero Button to set the dial to zero. Do
not clamp the Indicator too forcefully against the
object being measured. There must be room for the
needle to move in and out while under pressure.
4. Spin the rotor by hand to see if it is true. As the
rotor spins, the needle will move in and out. The
display will indicate the amount of difference in true;
the measurements which are above and below
the baseline you established at the beginning.
5. Press the inch/mm Button to have the Indicator
display switch between inches or millimeters.
Inch/mm
Figure A
Item 63613
ZERO
OFF/ON
For technical questions, please call 1-888-866-5797.
Replacing the Battery
1. Remove the battery cover located directly
on the top of the Digital Indicator by
gently prying it off - see Figure B.
2. Replace the battery with the type specified on
Page 2. Insert into the compartment with the
positive polarity facing the front of the product.
3. Replace the battery cover. Dispose of the
old battery immediately in accordance with
local ordinances for proper disposal.
Battery
Compartment
Figure B
Record Serial Number Here:
Note: If product has no serial number, record
month and year of purchase instead.
Note: Replacement parts are
not available for this item.
Page 3
Advertisement
