ADEMCO 5805-4 Installation Instructions

INSTALLATION INSTRUCTIONS

GENERAL INFORMATION
The 5805-4/6 is a compact, 4-button or 6-button
portable wireless transmitter intended for use
only with wireless alarm systems that support
5800 Series receivers. Each button on the
transmitter may be programmed for any zone
response, but is typically used for arming and
disarming.
This device supports the High-Security mode,
which sends rolling-code encrypted messaging
to the RF receiver.
Important Note: This device must be used
with a 5881EN or a 6128RF(UL version)
receiver.
The 5805-4/6 is powered by one replaceable
lithium battery designed to provide up to 4
years of life. For battery installation, see
Replacing the Batteries.
PROGRAMMING
Each 5805-4/6 is assigned a unique serial
number during manufacturing. Each button on
the unit also has a distinct "loop" number (refer
to Figure 1) that you must program into the
control panel during installation. Assign each
button to an individual zone and designate the
Input Type as "BR" (Button Type RF).
When you are prompted for the serial number,
both press and release twice the button you are
programming, or enter it manually through the
keypad.
For complete details on how to program the
5805-4/6 transmitter's serial number at the
control panel, see the control unit's installation
instructions.
Note: Buttons on this transmitter must be
pressed for at least 1/2 second to activate the
transmitter. This feature minimizes the
possibility of accidental transmissions.
ACTIVATING HIGH-SECURITY MODE
If Programming 5805-4/6 in the Control
1.
Program the button in the control.
2.
After programming
programming mode and wait 60 seconds.
3.
Put the system in Go/No Go mode.
WIRELESS KEY TRANSMITTER
4.
5.
6.
NOTE:
mode, and repeat this procedure from Step 3.
7.
If Programming the 5805-4/6 Locally in the
6128RF
Hold Loop 1, Loop 2, Loop 3 and loop 4 Down
To enroll the First serial number in the
6128RF.
Hold Loop 1, Loop 4 of first Serial # and Loop 2,
loop 3 of Second serial # to enroll Second serial
number in the 6128RF
IF USING TWO RECEIVERS IN HIGH-
SECURITY MODE
Enroll the 5805-4/6 into the receivers one at a
time, by disconnecting Receiver #2, enrolling as
described in "Activating High Security Mode"
(above).
is complete, exit
reconnect
enrollment procedure.
proper High Security operation with both
receivers.
To enroll hold Loop1, Loop2, Loop3 and
loop 4 down at the same time until the
panel beeps.
To sync the device in High Security Mode,
press any button ONCE, until the panel
beeps indicating receipt.
For Second serial number Hold Loop1,
Loop4 of first Serial # and Loop 2, loop3 of
Second serial # at the same time until the
panel beeps.
If no beep is heard, exit Go/No Go
Exit Go/No Go mode (user code + 1 (OFF)).
Figure 1: 5805-6 showing button designations
Note 1: To get second serial Loop 1 you need to
press and hold Serial # 2 Loop3 and Loop
2,To get Second serial loop 4 you need to
hold Serial # 1 Loop 3 and Serial # 2 loop 2
Then, disconnect
Receiver #2, and
This process ensures
5805-4/6
Receiver #1,
repeat the