Table of Contents
Advertisement
RF4QR/NA (SRT-8960 GB) Wed. May, 08/2002
SYNCHRONIZATION CONTROL
Setting the Cassette Eject Mode
Operator mode can be used to eject cassettes for all
VCRs or for specified VCRs.
1
Follow steps 1 to 4 under "Operator Mode".
2
Turn the JOG dial until the "EJECT MODE" setting is
highlighted, then turn the SHUTTLE ring clockwise.
3
Turn the JOG dial to select the desired cassette
eject mode, then turn the SHUTTLE ring clockwise.
EJECT1 . . . . . . . . . . . . The cassette is ejected
EJECT2 . . . . . . . . . . . . The cassette is ejected
4
Press the MENU EXIT button.
Administrator/Installer Mode
This mode lets you carry out basic operations (ejecting,
recording, stopping, rewinding and changing the
recording speed mode) and also make menu settings.
NOTES:
œ This mode will not work correctly unless the VCRs are
œ Menu settings will not work correctly unless the menu
only if the VCR is not in
recording or recording
pause mode.
œ If a power failure occurs, make the settings again.
1
only if the VCR is in stop
mode.
42
in the same initial state.
settings for the VCRs are the same. Set the menu
settings for each VCR to the initial setting before
using this mode to change the settings.
While holding the STOP button, press the
STILL/PAUSE button for 3 seconds or more on the
VCR that is set to be the master VCR.
ø "SC" will flash on the digital display.
"SC" flashes (master) . The menu settings can be
changed for the VCR
being operated and all
VCRs that are connected
after it.
œ This mode can be used regardless of the
"OPERATION" setting in the (WARNING
OUT/CONTROL SET) menu.
"SC" off (slave) . . . . . . The menu settings can be
changed for only the VCR
being operated.
œ To cancel the master mode, press and hold the
STOP button and then press the STILL/PAUSE
button.
English
Advertisement
Table of Contents
