Setting The Button Sound On/Off; Rm (Room Monitor) - Silvercrest SFG 8000 B2 Operating And Safety Instructions Manual

SilverCrest SFG 8000 B2
 Press the Menu
 Press the Up  button [10] to enable (ON) or the Down  button [7] to
 Press the PTT button [12] to confirm the setting and return to idle mode.

11.8. Setting the button sound on/off

An acoustic signal can normally be heard each time you press a button. This feature does not apply to the
On/Off button [5] or the PTT button [12]. If necessary, you can disable the button sound.
 Press the Menu
 Press the Up  button [10] to enable (ON) or the Down  button [7] to
 Press the PTT button [12] to confirm the setting and return to idle mode.

11.9. RM (Room Monitor)

You can use this function to monitor a room. While this function is enabled, the handheld transceiver will
transmit as long as voices or other noises are detected and without having to press the PTT button [12].
This lets you hear these voices or noises on the second handheld transceiver.
When using this function, use the handheld transceivers in different rooms. Otherwise a loud
whistle (feedback) may occur.
 Press the Menu
 Press the Up  button [10] to enable the Room Monitor.
 Press the Down  button [7] to disable the function ("RM OF").
 Press the Menu
 To exit the Room Monitor function, press the Menu
24 - English
button [6] nine times. The indication "rO" will be shown
and the current status will flash on the display.
disable (OF) the roger beep.
button [6] ten times. The indication "tO" will be shown and
the current status will flash on the display.
disable (OF) the button sound.
button [6] twelve times. The indication "RM OF" will be
shown and the current status will flash on the display.
button [6] to confirm the setting.
and then press the Down  button [7] as many times as necessary until "RM
OF" is shown. Press the Menu
button [6] eleven times
button [6] to confirm.