Table of Contents
Advertisement
<P=005>
SOUND CONTROL
(Main unit)
(Remote control)
0 - 40
(Main unit)
(Remote control)
(Main unit)
(Remote control)
DISPLAY SECTION
(Main unit)
(Remote control)
COMPACT DISC OPERATION
Caution:
Do not carry the unit whilst CDs are in the trays or a MiniDisc is
loaded. The discs may come loose inside the unit and they may
be damaged or cause damage to the unit. This may also cause
malfunctions.
Do not place two CDs in one disc position.
Do not push the disc tray whilst it is moving.
Do not attempt to push the disc tray by hand. This may cause
malfunctions.
If the power fails whilst the tray is open, wait until the power is
restored.
If the disc tray is stopped forcibly, "DISC ERR" will appear in the
display and the unit will not function.
If this occurs, press the ON/STAND-BY button to enter the stand-by
mode and turn it on again.
Volume
Press the VOLUME
ton to decrease the volume.
The volume display can be changed within the range of "0" to "40".
Pre-programmed equalizer
When the PRE-EQ button is pressed, the current mode setting will be displayed.
To change to a different mode, press the PRE-EQ button repeatedly.
FLAT
SOFT-1
Extra bass (X-BASS)
Press the X-BASS button to emphasise the bass region of the frequency spectrum.
"X-BASS ON" will appear.
Press the X-BASS button again to cancel the extra bass mode.
"X-BASS OFF" will appear.
You can change the brightness of the display.
When the power is on, press the DISPLAY button for at least two seconds.
The display section will become brighter.
To return to the original brightness, press the DISPLAY button again for at least
two seconds.
Note:
The brightness setting of the display is maintained even after the unit has entered
stand-by mode.
When bright
When dark
If TV or radio interference occurs during CD operation, move the
unit away from the TV or radio.
If a disc is damaged, dirty, or loaded upside down, the disc will be
skipped and the next disc will automatically play.
If the CDs are dirty or have label adhesive on their surface, make
sure to clean them before loading.
If the CD
button is pressed when a disc tray is open, the disc tray will
7
close automatically. Be careful not to catch your fingers.
If the unit is shaken by impact or vibration, playback may be dis-
rupted. If the playback volume of a CD is raised excessively, play-
back may be disrupted. If this occurs, lower the playback volume.
9
MD-X60H(SUK) TINSE0227AWZZ
button to increase the volume and the VOLUME
HEAVY-2
HEAVY-1
SOFT-2
VOCAL
button, any of the CD 1
- 3
0 6
0
but-
buttons or the
0
Advertisement
Table of Contents
