Chapter 3: Configuring The Storage System - Hitachi VSP Gx00 series System Administrator Manual

Chapter 3: Configuring the storage system

When configuring the storage system, you must set storage system information, set up
security, and register the SVP.
This chapter provides information about configuring the storage system.
System administration tasks at a glance
The following table summarizes key system administration tasks. The tool used to
perform these tasks depends on whether the storage system contains NAS modules.
Task
Set IPv4 and IPv6
network settings and
set HTTP blocking
Set system clock (date
and time)
Configure audit log
settings
Configure alert
notifications
Changing link
aggregation
System Administrator Guide for VSP Gx00 models and VSP Fx00 models
Table 2 System administration tasks at a glance
Block-only storage
systems (no NAS
modules installed)
Maintenance utility
See Changing network
communication
settings (on page 49)
Maintenance utility
See Changing the date
and time (on
page 48)
Maintenance utility
See Audit log settings
(on page 199)
Maintenance utility
See Alert notifications
(on page 177)
N/A
Chapter 3: Configuring the storage system
Block and file storage systems
(NAS modules installed)
IP addresses cannot be added,
deleted, or modified in the NAS
Manager. To change these
addresses, use the maintenance
utility.
NAS Manager
See Changing the system date and
time of the NAS Modules (on
page 55)
NAS Manager
See the File Services Administration
Guide (MK-92HNAS006) and the
Server and Cluster Administration
Guide (MK-92HNAS010)
NAS Manager
See the Server and Cluster
Administration Guide
(MK-92HNAS010)
NAS Manager
See the Network Administration
Guide (MK-92HNAS008)
45