Sharp XR-1X Operation Manual page 65

Problem
• Change the input signal type setting.
Picture is green on
INPUT 1 COMPONENT.
Picture is pink (no green)
on INPUT 1 RGB.
Picture is too bright and • Image adjustments are incorrectly set.
whitish.
The cooling fan becomes • When temperature inside the projector increases, the cooling fan
noisy. runs faster.
The lamp does not light • The lamp indicator is illuminating in red.
Replace the lamp.
up even after the
projector turns on.
The lamp suddenly turns
off during projection
The image sometimes • Cables incorrectly connected to the projector or the connected
flickers. equipment works improperly.
• If this happens frequently, replace the lamp.
The lamp needs much • The lamp will eventually need to be changed.
time to turn on. While the remaining lamp life draws to a close, replace the lamp.
Picture is dark.
This unit is equipped with a microprocessor. Its performance could be adversely affected by incorrect operation
or interference. If this should happen, unplug the Unit and plug it in again after more than 30 seconds.
Check Page
51
40
–
53
23, 24,
25, 51, 56
56
61