Connecting To A Monitor; Using As A Wired Remote Control - Sharp XG-C55X Operation Manual

Connecting to a Monitor

Watching Images on
Both the Projector and
a Monitor
You can display computer images on both the
projector and a separate monitor using two
sets of an RGB cable. An RGB cable is sup-
plied with this projector. You need to buy an-
other RGB cable for connecting the projector
to a monitor.
1
Connect the projector to the
computer and monitor using
RGB cables (one is supplied,
the other is sold separately).
2
In the "Options(1)" menu, se-
lect "Economy Mode", "Mntr.
out/RS232" and then "ON".
(see page 69.)
Note
• Analog RGB signals as well as Component
signals can be output to the monitor.

Using as a Wired Remote Control

Connecting the Remote
Control to the Projector
When the remote control cannot be used due to
the range or positioning of the projector (rear pro-
jection, etc.), connect a ø3.5 mm stereo or mono
minijack cable (commercially available or available
as Sharp service part QCNWGA013WJPZ) from
the WIRED R/C JACK on the top of the remote con-
trol to the WIRED REMOTE control input terminal.
Note
• FORWARD/BACK presentation control can-
not be used when the remote control is wired
to the projector. To utilize this feature, dis-
connect the cable from the remote control.
Supplied
accessory
Computer RGB cable
Optional
AN-C10BM
cable
(32'10" (10.0 m))
To RGB input terminal
RGB cable
(sold separately)
RGB cable
(supplied)
WIRED REMOTE control input terminal
RGB cable
Monitor
Desktop computer
To RGB output terminal
To WIRED R/C JACK
ø3.5 mm stereo or mono
minijack cable
(commercially available or
available as Sharp service
part QCNWGA013WJPZ)
-23